Bike Brake Lever
 ROAD BIKE 27 RACING BICYCLE CLASSIC BRAKE LEVERS SET US $19.35 
|
 Cane Creek Carbon 200TT Time Trail Bike Brake Lever Set US $32.87
|
 New Tektro RL721 Cyclocross Bike Brake Levers Silver US $19.99
|
 New 700C Road Bike Bicycle Caliper Brake Lever Black One Pair US $.10
|
 BICYCLE BIKE 27 ROAD RACING BRAKE SET LEVER 2 Way Pull US $17.99
|
 SHIMANO ST 2300 Bike STI Shifter Brake Lever Front NEW US $49.97
|
 Replacement Bike Bicycle Right Left Brake Levers Parts US $6.72
|
 APSE BICYCLE BRAKE CLUTCH LEVER BIKE PARTS 15 US $9.99
|
 PAIR BIKE GREEN MTB CNC C BRAKE LEVER Light 73G LEVERS US $89.95
|
 Black Plastic Handle Hand Brake Levers for Bike Bicycle US $6.70
|
 PAIR BIKE RED MTB CNC C BRAKE LEVER Light 73G LEVERS US $89.95
|
 PAIR BIKE GREEN ROAD CNC C BRAKE LEVER Light 73G LEVERS US $89.95
|
 27 ROAD BIKE BICYCLE CLASSIC BRAKE LEVERS 1 PAIR NEW US $19.35
|
 Bike Bicycle Black Plastic Handle Hand Brake Levers US $7.03
|
 2 BICYCLE BIKE 27 ROAD RACING BRAKE LEVER 2 Way NEW TW US $22.50
|
 ROAD BIKE RACING BICYCLE CLASSIC BRAKE LEVER SET NEW TW US $19.35
|
 New SRAM S500 brake lever for Road bike black US $89.00
|
 Replacement Bike Cycling Front Rear Brake Levers Black US $7.02
|
 Tektro RL340 Road Bike Bicycle Brake Lever Set1 Pair US $23.87
|
 TEKTRO ML 330 MOUTAIN BIKE BRAKE LEVERS US $10.00
|
 Shimano Dura Ace Di2 Shifters Brake Lever TT Triathlon Bar End Road Bike US $162.82
|
 Brand New Shimano BL R780 flat bar Brake levers for road bikes US $30.00
|
How to Give your bike a lube job ?
When you clean your bike, you'll likely remove a lot of lubrication and your bike will be thirsty for a fresh dose of oil and grease.
If you're a typical recreational rider, you may only have to give your bike a quick lube job every week or two. But if you're riding in wet weather or you're taking long bike trips, you should oil your bike more frequently. Just like the pre-ride inspection (earlier in this chapter), a lube job is quick and easy — you can do it in a few minutes, and it'll provide many benefits for your bike.
Many of the parts of a bike that require oil are not fully exposed, which makes it harder to get the oil into the right place. For this, we recommend using a spray can with a thin, straw-like extension. You'll be able to insert the extension into small, hard-to-reach areas such as inside the brake levers.
Here are the parts of your bike you'll want to lubricate after cleaning:
Brakes: Spray some oil into the brake pivot points to keep them in working order and to prevent rust. Be careful not to get any on the brake pads or rims, because this will impact your bike's braking capacity. Also, give a shot of lube to the spot where the cable is attached.
Brake levers: Apply oil to the brake-lever pivots. Pull back on the brake lever and spray the exposed cable. Be sure to cover the cable adjusters with lube to protect them from rust.
Derailleurs: There are several pivot points where the front and rear derailleurs move. Cover each of these with a quick shot of lube. On the front derailleur, lubricate the pivot point On the rear derailleur, be sure to spray both of the pulley wheels.
Chain and sprockets: Of all the parts to lubricate on a bike, the chain is the most important. A poorly lubricated chain will wear out quickly and can shorten the lifespan of your chainrings and sprocket. Apply an even amount of lube to the chain while you're turning the cranks (see Figure 16-9). You want to make sure that the oil does more than coat the surface but works its way into the individual chain links. If you notice that there is buildup of dirt and grime on the chain, clean it first with a degreaser and then apply a fresh coat of lubrication. When you're finished with the chain, apply a few drops of lube to the sprockets.
Cables: Give a light spray of oil to where the inner cable exits from the cable housing. If you have a couple of minutes, remove the cable from the stop and give a spray into the cable housing.
After you're done lubricating your bike, be sure to use a rag and wipe any excess oil off your bike to prevent it from attracting dirt and grime.
About the Author
woodchuck is an up and coming expert on crafts and hobbies. Do you want complete Band Saw Table Plans? You can learn wood DIY Bench Hold Down plans, or you can learn adoption process by going to How to Adopt A Baby site.
People Love These Road Bike Parts:
